Get Oil Filter Housing Application Guide 2020-2025

The Factory-Assembled, Drop-In Replacement Standard® Oil Filter Housing Assemblies include the vehicle-specific Filter, Cap, Bypass Valve, Heat Exchanger (Cooler), Gaskets, Hardware and both the Oil Temperature and Oil Pressure Sensors.

0:54 7:34 HOW and WHY to relocate your OIL FILTER - YouTube YouTube Start of suggested clip End of suggested clip Into the adapter. After that you can screw the entire assembly into the block. As you would withMoreInto the adapter. After that you can screw the entire assembly into the block. As you would with your oil filter the oil filter. Itself is of course installed into the other part of the kit.

Without the oil filter housing, engine oil would not be able to flow through the filter efficiently. If not replaced, a broken oil filter housing will result in contaminated oil circulating through the car's engine, which can lead to catastrophic engine damage.

The oil filter housing on most cars is located in a spot that's easily accessible for oil and filter changes, typically either on the top of the engine near the front or on the side of the engine with the filter accessible from the bottom.

What is Oil Filter Housing? The oil filter housing is a housing used for oil filters inside the engine bay. It is something that connects the oil filter with the engine by securing it at one place. To put it simply, Oil filter housing provides a safe place for the oil filter to do its job.

This service typically takes less than 15 minutes to complete. A mechanic can help replace your oil filter housing, which secures the car's oil filter in place, allowing engine oil to flow freely through the car to reach vital engine parts if it is broken or damaged.

0:18 2:23 Torque Specifications On Cartridge Oil Filter Caps | Tech Minute - YouTube YouTube Start of suggested clip End of suggested clip Some manufacturers may use a plastic cap on these that have a torque specification of anything fromMoreSome manufacturers may use a plastic cap on these that have a torque specification of anything from 15 to 25 foot-pounds. It's critical that you look up the specification.

In addition to oil, you'll need an oil filter, an oil-filter removal wrench, a wrench to remove the drain plug, a funnel, a drain pan and some gloves. You may also need to raise the car to gain access, in which case you'll need a floor jack and safety stands, or a pair of purpose-made steel ramps.