Get Lifeline Inspection Checklist

For the equipment to remain safe and compliant, your height safety equipment needs to be tested, inspected and tagged every 6 to 12 months by a competent, trained and accredited person. The inspection and certification periods for height safety equipment are; Lifting Slings 3 months.

ISO 16024:2005(en), Personal protective equipment for protection against falls from a height Flexible horizontal lifeline systems.

If designed for the proper forces as required by OSHA's 29 CFR Subpart M, it can hold the number of employees you need it to hold (the oft-quoted 5000 lbs per worker attached is the regulation most go by, but it is important to note that OSHA states in their regulations that what is actually required is a safety factor ...

In simplest form, the horizontal lifeline consists of a cable attached to two or more anchor points on a roof-top, crane runway, bridge or outdoor construction site, or any other elevated work area that poses a fall risk to personnel. ...

OSHA 1926 states that the direct connection of a snap hook or carabiner to a horizontal lifeline is a potentially incompatible connection, unless designed for such use by the manufacturer.

Prior to each use, a harness must be inspected for deficiencies including corrosion, deformation, pits, burrs, rough surfaces, sharp edges, cracking, rust, paint buildup, excessive heating, alteration, broken stitching, fraying, and missing or illegible labels.

HSE guidelines recommend an inspection by a professional service every 6 months but PPE regulations require a minimum of 12 monthly inspections which should be recorded on the harness itself.

Check the label. - Confirm that the label has an individual serial number. - Confirm that the label has a valid inspection date and that there were no reported problems. ... Hardware check. Check condition of rear D Ring for: ... Software check. - Hold the harness up by the shoulder straps and ensure that the webbing hangs evenly.

Should a horizontal lifeline be taught and straight without slag from one anchor to another? ... Yes it should be straight without slag, the ends of the line could potentially be terminated far enough back so that even workers at the very ends could not go over the edge of the roof in a way that would produce swing.

Horizontal lifelines shall be designed, installed, and used, under the supervision of a qualified person, as part of a complete personal fall arrest system, which maintains a safety factor of at least two.