Get Osha Scaffolding Requirements Pdf

SCAFFOLD CHECKLIST Scaffold square, straight, and plumb in all directions. All scaffold components present, tight and secure. No tubes or members over-extended and hazardous. Leveling adjustment screws extended less than 0.3 meters and lock nuts tightened. General Scaffold Inspection Checklist - SafetyCulture Public Library safetyculture.io https://public-library.safetyculture.io › products › genera... safetyculture.io https://public-library.safetyculture.io › products › genera...

Check legs, posts, frames and uprights to see if they are on baseplates and mudsills. Check metal components for bends, cracks, holes, rust, welding splatter, pits, broken welds, and non-compati- ble parts. Check for safe access. Do not use the crossbraces as a ladder for access or exit.

It is the scaffold users/hirers responsibility to ensure that all scaffolding has been inspected as follows: following installation/before first use. at an interval of no more than every 7 days thereafter. following any circumstances liable to jeopardise the safety of the installation eg high winds.

check that scaffold boards are properly supported and not overhanging excessively e.g. no more than four times the thickness of the board. ensure there is safe access onto the work platforms, preferably from a staircase or ladder tower. Construction - Scaffold checklist - HSE hse.gov.uk https://.hse.gov.uk › safetytopics › scaffoldinginfo hse.gov.uk https://.hse.gov.uk › safetytopics › scaffoldinginfo

Safety takes precedence and includes the following: The 3 to 1 rule. The total working height of a freestanding scaffolding tower should be three (3) times the distance of the narrowest side of the base (if this is a measurement of outriggers, they must be set symmetrically about the tower).

A partially erected scaffold may not have guardrails, or ladders, and be properly tied or be fully planked. Therefore, it would be a hazard and fall under the defective equipment category until the scaffold is completed and all safety features installed. Consequently, a warning tag should be used.

Employers are required by OSHA standards to have a qualified person provide training to each employee who performs work while on a scaffold. The training must enable employees to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.

OSHA requires the general contractor in section 1926.451(f)(3) to have scaffolds and scaffold components inspected for visible defects by a competent person prior to each work shift and after any occurrence which could affect a scaffold's structural integrity.