Get Eight Team Simple Consolation Tournament Form

Stacked Chart. Bar charts are best used when showing comparisons between categories. Typically, the bars are proportional to the values they represent and can be plotted either horizontally or vertically.

A traditional bar chart displays a single categorical variable in the form of bars. A stacked bar chart shows two categorical variables. The first (and primary) variable is shown along the entire length of the bar, and the second variable is represented as stacks within each categorical bar.

You can use the Value Ordering column property in the data table to change the order of the stacked elements. All bars will use the order from the column property.

The stacked bar chart (aka stacked bar graph) extends the standard bar chart from looking at numeric values across one categorical variable to two. Each bar in a standard bar chart is divided into a number of sub-bars stacked end to end, each one corresponding to a level of the second categorical variable.

0:06 0:54 How to change the order of the bars in your stack bar chart - YouTube YouTube Start of suggested clip End of suggested clip So if you're looking to reorder the columns. In your stack bar chart. This is the best way to do itMoreSo if you're looking to reorder the columns. In your stack bar chart. This is the best way to do it without manipulating the original data. Thanks a lot for watching I hope this helps.

Edit or rearrange a series Right-click your chart, and then choose Select Data. In the Legend Entries (Series) box, click the series you want to change. Click Edit, make your changes, and click OK. ... To rearrange a series, select it, and then click Move Up or Move Down .

How can you change the order of legend and data? Go to the “Set up” tab in the chart editor. Move on to the “Series” section and change the order of the series as you want. ... The legend and the order of segments in bars are automatically updated.

On the Format tab, in the Current Selection group, click Format Selection. In the Axis Options category, under Axis Options, select the Series in reverse order check box.