Get Tricon Water Heater Start-up Report See Installation And

While holding the pilot igniter button down, press the spark generator button. Keep holding the pilot igniter button for 20 to 30 seconds until it lights. If the water heater pilot doesn't light after this amount of time, you may need to press the spark generator down every 10 seconds until it does.

2:16 4:15 How To Relight A Water Heater Pilot Light - YouTube YouTube Start of suggested clip End of suggested clip Light on the right side of the valve. Blink. Once it blinks you can release the knob. And turn it toMoreLight on the right side of the valve. Blink. Once it blinks you can release the knob. And turn it to the desired.

0:57 3:06 How to Reignite a Hot Water Heater : Hot Water Heaters - YouTube YouTube Start of suggested clip End of suggested clip This is depressed. You'll be able to hear the hissing sound of the gas flowing immediately use aMoreThis is depressed. You'll be able to hear the hissing sound of the gas flowing immediately use a long match or one of the long trigger lighters to light the gas coming through the pilot assembly. Or.

Electric water heaters don't have a pilot, so the process is simple. First, make sure the breaker that controls the water heater is switched off. Check for any open valves or faucets and close them. Then, turn on the cold water to let the hot water tank fill.

The pilot light on most water heaters can be found at the base of the unit just under the gas control valve. Open the access door or panel to the burner chamber and take a look inside. You should be able to see the pilot light tube. If there's a steady blue flame, your pilot light is operational.