Get Material And Equipment Standard

Storage areas should be clearly defined....When stacking: Each stack should be for one material only (not mixed). A maximum stack height must be set (depending on the strength and stability of the material being stacked). Stacks should be vertical (not leaning). Pallets should be used to keep materials off the ground.

Housekeeping. All places of employment shall be kept clean to the extent that the nature of the work allows. The floor of every workroom shall be maintained, so far as practicable, in a dry condition.

The recommended width of aisle markings varies from 2 inches to 6 inches; therefore, any width 2 inches or more is considered acceptable. The recommended width of aisles is at least 3 feet wider than the largest equipment to be utilized, or a minimum of 4 feet.

1150.01 General Provisions: (1) Use of Mechanical Equipment. Where mechanical handling equipment is used, sufficient safe clearance shall be allowed for aisles, at loading docks, through doorways and wherever turns or passage must be made.

1926.250 - General requirements for storage. Occupational Safety and Health Administration.

Always make use of conveyors, slides or other devices, to avoid unnecessary lifting or pushing of objects. Always go around a blocked pathway, never step over an obstacle while carrying material. Maintain a clear line of site; objects should not block vision; lift only where there is sufficient lighting.

Storage of material shall not create a hazard. Bags, containers, bundles, etc., stored in tiers shall be stacked, blocked, interlocked and limited in height so that they are stable and secure against sliding or collapse. Housekeeping.

Storage of material shall not create a hazard. Bags, containers, bundles, etc., stored in tiers shall be stacked, blocked, interlocked and limited in height so that they are stable and secure against sliding or collapse.