Get Midland Weather Radio Manual

The flashing of the lights and occasional beeping of the unit is typically caused when the radio has not received a Required Weekly Test (RWT) for more than ten days.

0:05 0:59 You can go down to single if you want to specifically. Bring in one or two counties alone you can doMoreYou can go down to single if you want to specifically. Bring in one or two counties alone you can do multiple. But if you want to hear weather alerts for the entire area you can select any.

0:53 1:39 Remove one of the batteries from the back. Just one hold down with your thumb or your fingers theMoreRemove one of the batteries from the back. Just one hold down with your thumb or your fingers the weather snooze button and hold it down and keep it held. Down.

0:06 0:39 How to set the time on a Midland weather radio - YouTube YouTube Start of suggested clip End of suggested clip To the specific hour then use the cursor right to change the time. After you've selected it a.m. andMoreTo the specific hour then use the cursor right to change the time. After you've selected it a.m. and p.m. then hit select one more time and that will select your time.

How to Set Up the Midland WR-100 Weather Radio Plug-in the radio, turn it on (switch on right side) and fully extend the antenna. Menu wraps around TIME, ALARM, CHANNEL, SAME SET, ALT TYPE, ALT TEST and LIGHT. Press UP arrow - 'CHANNEL' is displayed. Press SELECT - Radio comes on so you can hear the broadcasts.

The most likely cause is that you have not programmed your receiver correctly, or the programming has been lost or changed without your knowledge. Use these maps, or this site which lists counties by state and double check that your receiver is tuned to a NWR transmitter which broadcasts warnings for your county.

0:26 2:24 How To Program the Midland WR-120 Weather Radio - YouTube YouTube Start of suggested clip End of suggested clip And write down the corresponding. Six digit codes then press the menu button and hit the down arrow.MoreAnd write down the corresponding. Six digit codes then press the menu button and hit the down arrow. Until set location is displayed.

Programming Your Midland Weather Radio Is as Easy As 1-2-3 Set switch on right side to ON. backup batteries if power goes out. SET YOUR LANGUAGE by pressing SELECT. Next it says SET TIME, press SELECT and enter your local time using arrow buttons.