Get Actuator Inquiry Form

Pneumatic actuators valve Pneumatic actuators are designed to operate a piston within a closed cylinder. Pressure from an external air or gas source powers the actuator, moving the cylinder to fully open or close the valve, or partially modulate its open/close movement.

If the valve still doesn't move, then the problem is most likely the valve. If the valve does operate in manual mode, then you may have an actuator problem....The valve A worn out valve stem. Seized up packing. An obstruction. Too much torque.

An actuator is a device that produces a motion by converting energy and signals going into the system. The motion it produces can be either rotary or linear. An actuator is a device that produces a motion by converting energy and signals going into the system.

Pneumatic Actuators are powered by compressed gas from an external source, most commonly dry clean air. Usually, a single air compressor can drive several pneumatic actuators at the same time which gives them an advantage over other types of actuators especially if the system has a large number of valves.

What is the Primary Function of a Pneumatic Actuator? A pneumatic actuator, unlike the other ways to power an actuator, is primarily used to power a valve within a system. They convert pressurized air into energy to keep a system operating smoothly. This can be for gas, load or water movement.

The actuator is the next logical area of interest. The operation of a control valve involves positioning its movable part (the plug, ball or vane) relative to the stationary seat of the valve. The purpose of the valve actuator is to accurately locate the valve plug in a position dictated by the control signal.