Get Bruno Sre 2010 Installation Manual

Install the stair lift tracks. ... Put the control cable in place. ... Fit the stair lift seat in place. ... Install the leg rest and align it with the seat. ... Push down on each bracket and make sure all loose brackets are tightened.

To reset, turn the power switch off (located on the stairlift) for 30 seconds (see page 16). Batteries low (17 volts or less) re charge batteries. Try a reset. If this does not clear the display and the lift fails to operate, call your ACORN representative for further instructions.

In most cases, the stairlift for sale will not fit your stairs. All straight stairlift rails are cut to the correct size for the staircase it is to be fitted to.

These batteries are then recharged automatically once the stairlifts parked. This charge comes from the nearest plug socket / fuse spur and is feeded to a charging point or a charging strip which is located on the track. Once stairlift is parked it connects to the charging system.

Most stairlifts will beep to let you know that they are off charge. This to avoid the batteries draining completely leaving you unable to use the stairlift at all. If your stairlift does start to beep, make sure: ... the stairlift is parked correctly at the top or bottom of the stairs on it's charge point.

Replacing a stairlift battery means you'll need to remove some parts of the stairlift carriage, extract the old battery and install a new battery of the correct voltage. Then you'll have to make sure to put the chair lift carriage back together the way it should be.

Most stairlifts will beep to let you know that they are off charge. This to avoid the batteries draining completely leaving you unable to use the stairlift at all. If your stairlift does start to beep, make sure: ... the stairlift is parked correctly at the top or bottom of the stairs on it's charge point.

If your stair lift isn't moving, the first thing you should check is whether the key is in the correct position. Depending on your stair lift model, your key switch is located on the top landing chassis side or on the lower front cover of the chair's armrest.

Purchase the batteries required by your Bruno stairlift, which are two rechargeable 12-volt batteries. Examine the battery charger to determine where you need to put the new batteries. ... Remove the old batteries from the charger. ... Place the new batteries where you removed the old ones.

Your stairlift will beep if the batteries are not being charged. Check the wall switch is on. ... Check the stairlift is parked correctly at the top or bottom of the stairs. If you have checked these things and your stairlift continues to beep switch your stairlift off and call your local branch.

My stair lift is constantly beeping Please check that your stairlift is parked in the correct position at the charging point (which is usually at the top or bottom of the stairs). Also check that the wall switch and mains power switch is on or that there has not been a power cut.

Stairlift batteries generally last around 2 to 5 years, of course, this depends on the usage. For example, if the stairlift is often left off its charge point it degrades the battery and results in early replacement.