Get Autoclave Maintenance Checklist

For better results, clean autoclave every 20 cycles or once a week. Sprinkle Chamber Brite powder along the bottom of the autoclave chamber. ... Start a sterilization cycle with distilled water but no drying cycle. At the end of the cycle, drain solution from reservoir and discard.

Typically it's the larger square section autoclaves and machines fitted with a vacuum require servicing up to four times a year. Smaller capacity autoclaves, including most circular section machines require servicing once or twice a year depending on regularity of use.

0:13 4:21 How to Perform Monthly Maintenance on a Midmark M9®/M11® Steam ... YouTube Start of suggested clip End of suggested clip Run one pouches cycle. But push the stop button when the drying cycle begins. It's not necessary forMoreRun one pouches cycle. But push the stop button when the drying cycle begins. It's not necessary for the dry cycle to run during this maintenance drain.

1:49 3:16 How to Clean and Care for Your Midmark M9®/M11 ... - YouTube YouTube Start of suggested clip End of suggested clip After removing the trays and rack from the autoclave. Clean the trays in the inside of the chamberMoreAfter removing the trays and rack from the autoclave. Clean the trays in the inside of the chamber with distilled water and speed.

Annual Autoclave Maintenance Inspect and replace the door gasket. Inspect water and air filters. Lubricate the door latch. Check the system for leaks.

How Do I Clean My Autoclave Chamber? Remove shelf racks from the chamber, but leave the chamber drain strainer in place. Spray cleaning solution either onto a cleaning pad or directly onto the chamber walls. ... Using a back-and-forth scrubbing motion, scrub the chamber walls, ceiling, and floor.

Autoclave maintenance To keep the autoclave in good running order, dry door seals and gaskets after each cycle with a lintfree cloth. Change door gaskets every two-three months or at a frequency stated by the manufacturer. Carry out a residual air tests and an air leakage test weekly.

For proper maintenance of the autoclave, periodically clean all the external parts, using a soft cloth dampened with regular neutral detergents (NB: do not use corrosive or abrasive products). Do not use common abrasive cloths or wire (or other abrasive) brushes to clean the metal parts.