Get Cover Measuring Form

If yours is a mesh cover, it should be almost “taut as a drum”, as the water will drain through it evenly. If yours is a solid cover, either with an automatic cover pump or a porous drain strip, it should be kept slightly less tight in the area of the pump or drain strip.

0:04 1:47 How to a rectangle safety cover - YouTube YouTube Start of suggested clip End of suggested clip Basically. It's the same process that would use for any other type of installation. Just somewhatMoreBasically. It's the same process that would use for any other type of installation. Just somewhat simplified. So essentially you would stretch the cover out over the surface of the pool.

3:40 5:24 We'll simply measure from the outer edge of the step. Not the inner edge or water surface.MoreWe'll simply measure from the outer edge of the step. Not the inner edge or water surface.

Paver Pool Deck Anchors Use an extra long drill bit to drill a hole into the earth between the pavers (or at the joint of 3 pavers if they are a very tight fit). Place a piece of wood over the top of the paver tube and pound it into the hole until it is flush with the deck. Place a brass anchor into the tube.

2:20 5:09 Select the two straps on either side of the installed strap. Follow step 5 again to secure the coverMoreSelect the two straps on either side of the installed strap. Follow step 5 again to secure the cover along its length. Next select the center strap crossing the width of the pool.

Pool cover installation is not difficult and can be done by almost anyone, using every day tools and a careful patient approach.