Feature Line Form For Free

Creating Feature Lines in Civil 3D - YouTube YouTube Start of suggested clip End of suggested clip Select the feature line drop down. And select create feature lines from objects. Our command line isMoreSelect the feature line drop down. And select create feature lines from objects. Our command line is asking us to select the line. So we'll select this one and this one go ahead and press enter.

Adding a Feature Line to a Surface as a Breakline Right-click a feature line Add To Surface As Breakline. Note.In the Select Surface dialog box, select a surface, and press OK. Or, select the Add button to create a new surface. In the Add Breaklines dialog box, specify the breakline options. Press OK.

Grading: Fun with Feature Lines - YouTube YouTube Start of suggested clip End of suggested clip Let's take a look at the elevations of that feature line if we go to the editor. So the top where weMoreLet's take a look at the elevations of that feature line if we go to the editor. So the top where we started was 809. And we were grading. Down about -3 that was a natural slope there roughly.

To Create Feature Lines From Alignments Click Home tab Create Design panel Feature Line drop-down Create Feature Lines From Objects Find. In the drawing, select an alignment. Then press Enter. In the Create Feature Line From Alignment dialog box, specify the feature line options.

Fillets a feature line, survey figure, or 3D polyline. This command can be used to round the corners of feature lines. The fillet can span multiple segments and can be used to join two connecting feature lines.

So this is the edge of the gutter, the flow line, the top face, and the top back. So that's what Feature Lines do, they represent edges or linear objects in a three dimensional form in your drawing model.

To Offset a Feature Line by Distance and Elevation Click Home tab Create Design panel Feature Line drop-down Create Feature Line From Stepped Offset Find. Do one of the following to specify the location for the offset:Do one of the following:Select another object to offset, or press Enter to end the command.