Feature Line License For Free

FLEXlm was originally a joint development of GLOBEtrotter Software and Highland Software in 1988. GLOBEtrotter was then acquired by Macrovision in 2000, which renamed the product FlexNet.

A FEATURE line does not give an additional number of licenses, whereas an INCREMENT line ALWAYS gives an additional number of licenses. There is a rarely used option in FLEXlm which causes FEATURE lines to function as INCREMENT lines.

Full pathname to the license file. Otherwise, LM_LICENSE_FILE is used, or the default location: /usr/local/flexlm/licenses/license. dat (Unix) or C:\flexlm\license.

On the FlexNet license server, the license manager sends the request to the vendor daemon. The vendor daemon checks if licenses are available. If there are available licenses, the vendor daemon grants a license and the Rational product runs. If licenses are not available, the vendor daemon refuses the request.

License files usually begin with a SERVER line (or three lines for three-server redundant servers) followed by one or more VENDOR lines, followed by one or more FEATURE or INCREMENT lines. In some cases the license file requires no SERVER line and no VENDOR line.

So this is the edge of the gutter, the flow line, the top face, and the top back. So that's what Feature Lines do, they represent edges or linear objects in a three dimensional form in your drawing model.

Edit geometry tools 2 Select blue feature line. Contextual ribbon > Edit Geometry panel > Edit Curve. Select feature line curve to edit or Delete: Click feature line curve. Radius: 87' Apply OK.

Feature lines, which represent the point objects such as road crowns, curb tops or backs, in the assembly. These point objects are converted to lines in the plan view of the corridor.

Use the Break command to break a feature line into two feature lines. The prompts for this command are similar to the AutoCAD Break command. Click two points to specify both sides of the break.

Use this command to trim feature lines so that they end precisely at boundary edges defined by other objects. Click Modify tab Edit Geometry panel Trim Find. Select the objects to serve as cutting edges. Select the feature line(s) to trim.