Unify Radio Release For Free

You'd click on the AP for which you want to disable 2.4 GHz, then click the sprocket icon for its settings, then go to the WLAN section, and set the 2.4 GHz radio to disabled.

Um but that's that's what you do to do that and then it'll be ready to set up again. Um like new.MoreUm but that's that's what you do to do that and then it'll be ready to set up again. Um like new. The other method is SSH. So if I look down on our guide. Here.

Restore to Factory Default Settings Press and hold the Reset button for more than five seconds. Alternatively, the UniFi AP may be reset remotely via a Reset button located on the bottom of the Gigabit PoE adapter. Cable Feed Plug If your Ethernet cable feeds along the mounting surface, remove the Cable Feed Plug.

And then hold down the reset button for about 15 seconds. And we should see the color on the accessMoreAnd then hold down the reset button for about 15 seconds. And we should see the color on the access point change you guys might not be able to see it too well. It. Just actually switched to amber.

The LED will flash white for a few seconds, then turn off, and finally flash white again. Once the LED light turns off and starts flashing white again, you can release the reset button. The UniFi AP AC Pro will take a few minutes to reboot and restore its factory settings.

UniFi APs have a physical reset button, usually located next to the ethernet port. Once the button is located, hold it down for 10 seconds, until the LED lights flash. Once done, the AP will reboot and then go back to factory default settings.

TLDR: The default username and password for Ubiquiti UniFi access points (and many other Ubiquiti products) is: Username: ubnt Password: ubnt. So, you've just got your shiny new UniFi Access Point and have yet to go through the setup process of installing the unit.