Write Over Radio Charter For Free

Walkie Talkie "10 Codes" 10-1 = Receiving poorly. 10-2 = Receiving well. 10-3 = Stop transmitting. 10-4 = Message received. 10-5 = Relay message to ___ 10-6 = Busy, please stand by. 10-7 = Out of service, leaving the air. 10-8 = In service, subject to call.

Here are some key phrases to remember: Over ? I've finished speaking. Say again ? Please repeat your last message. Stand by ? I acknowledge the transmission but can't respond right now. Go ahead ? I can respond, go ahead with your message. Roger ? Message received and understood. Affirmative/Negative ? Yes/No.

?Over?, used at the end of a transmission, tells the receiver that the transmitter has finished that section of their broadcast and is expecting and will await a response. ?Out? means that the transmitter has finished speaking and is not expecting to hear any more from the receiver. Ie.

Write Your Broadcasting Script as if You're Speaking Write as if you're speaking off-the-cuff, complete with contractions and slang. Avoid formal writing that sounds stiff and unnatural. One way to achieve this is by recording your script in your own words to sound like how you speak.

"Over the radio" is commonly used when talking about two-way communication, or when emphasizing the medium: The watch towers can communicate with each other over short-wave radio.

Some radios beep when you're done transmitting, in which case you wouldn't need to say "OVER", but it is still a good practice. It's basic "radio etiquette" to establish contact and make sure that you have the other person's attention before you start your message.

?Roger? represents the letter ?R?, meaning ?received and understood?. Fair enough. However ?over and out? is tosh. Radio (as opposed to phone) communication is half duplex. This means communication can occur in both directions (duplex) but only in one direction at any one time (half duplex).